Voir le texte source

Getting the clothes clean is all about choice and water temperature of soap. For those who have trouble controlling your washer's water temperature, your water inlet valve may be at fault. This article follows up on the first article: Washer Woes: Part One Water Temperature. If youve currently read Part One and are still having problems controlling your washer's water temperature, read on to learn how to analyze, test, and change your water intake valve. Water enters the water inlet valve through two tubes that result from the recent and cold water taps in your wall. Solenoids inside the water intake valve develop the selected water temperature and react to the temperature selector switch. The combined hot and cold water leaves the water inlet valve through a line, filling your machine using the right temperature of water. Never try any repairs or maintenance on-your washer without ensuring the power to your washer is disconnected you will be seriously injured if the power isn't disconnected. The water inlet valve is located at the back of your washer (inside the cabinet). Before examining the water inlet valve, always check the water flow. Shut-off the water taps (at the wall) and remove the hoses from the back of the washer. Area the disconnected end of each line in a empty container and activate the water. Now always check the movement of water and to be sure the hoses aren't blocked. Remove and examine the water intake valve, If the water flow seems to be right. The valve is held in position by two screws. Remove the screws and then remove the valves washer complete hose by loosening the clamp that holds the hose set up on the device. Now that the valve is removed, use a small, flat-head screwdriver to pop-out the valves intake screens. Carefully examine and clean any dirt from the monitors. Be cautious not to damage the displays - they can't be replaced. Dig up additional information on our affiliated website - Click here:  [http://tucliche.com/2013/12/30/auto-scratches-go-away/ tsd cleaning services] . If the displays are free from dirt, the next step would be to test the device. To check the water intake valve, find the wires attached to the devices o-n each solenoid. So you can remember just how to reconnect them label the wires just before treatment. The cables are secured in position by metal slip-on ties. When disconnecting the cables, use needle-nose pliers to-remove the connector from the final. Move the connector, not the wire. If the connectors and terminals are rusty or corroded, replace the device. Test your water intake valve for continuity, when the connections are good. You can certainly do this having a multitester. Set your multitester to the ohms resistance level X1. Each solenoid has two terminals. Test one solenoid at any given time by using each of the meter's probes and holding one to each terminal. Numbers may be different for every brand or product, but then a solenoid is broken and the device should really be replaced, if you get a result of infinity. To displace the old valve with a new one, join the fill line to the new valve and secure it in place with the screws. Connect the water warm and cold water tubes, and the wires to the solenoid terminals to the valve openings. Turn-on the water, when everything is secured. Check hoses for leaks and the water inlet valve before turning on your washer and running it by way of a period. Sometimes there's no-way of understanding what is wrong with your water inlet valve and replacing it may be the only option. If you find this restoration difficult to-do, or if you do not have an ohmmeter or a multimeter, contact a site technician.CarpetFirst 78 York Street London W1H 1DP 020 8099 8444