Voir le texte source

As a CCNP candidate and a CCNA, you may possibly be tempted to skip or just browse the several details of Spanning Tree Protocol. Right after all, you learned all of that in your CCNA studies, appropriate? That's proper, but it by no means hurts to evaluation STP for a switching exam! In addition to, numerous of us believe of the four STP port states - but officially, there is a fifth one! Disabled is not generally believed of as an STP port state, but Cisco does officially consider this to be an STP state. Be taught more on this affiliated portfolio - Click here:  [http://www.adamsairconditioning.net/ jupiter island air conditioning] . A disabled port is one particular that is administratively shut down. Once the port is opened, the port will go into blocking state.  [http://www.adamsairconditioning.net/ Advertisers]  includes new information concerning the inner workings of this activity. As the name implies, the port can't do a lot in this state - no frame forwarding, no frame receiving, and therefore no studying of MAC addresses. To get one more standpoint, people should check out:  [http://www.adamsairconditioning.net/ air conditioning system] . About the only factor this port can do is accept BPDUs from neighboring switches. A port will then go from blocking mode into listening mode. The clear question is &quot;listening for what?&quot; Listening for BPDUs - and this port can now send BPDUs as effectively. The port nonetheless can not forward or receive data frames. When the port goes from listening mode to studying mode, it is getting prepared to send and acquire frames. Going To  [http://www.adamsairconditioning.net/ compare 24 hour air conditioning service]  certainly provides tips you might tell your friend. In learning mode, the port starts to learn MAC addresses in preparation for adding them to its MAC address table. Lastly, a port can go into forwarding mode. This makes it possible for a port to forward and get information frames, send and acquire BPDUs, and spot MAC addresses in its MAC table. To see the STP mode of a provided interface, use the show spanning-tree interface command. SW1#show spanning-tree interface quick /11 Vlan Role Sts Price Prio.Nbr Kind ---------------- ---- --- --------- -------- ---------- VLAN0001 Desg FWD 19 128.11 P2p To see these states in action, shut a port down in your CCNA / CCNP property lab and continually run the show spanning interface command. Once you see this in action on genuine Cisco gear, you will have no dilemma with BCMSN exam inquiries. Just do not practice this or any other Cisco command on a production network!.Adam's Air Conditioning, Inc. 435 NW Enterprise Blvd. Port Saint Lucie, FL, 34986 772-337-6559 561-525-6330