Voir le texte source
De WikiCinéjeu.
pour
An Read Window glass repair part 2
Aller à :
Navigation
,
rechercher
This week we are likely to continue our line o-n single-pane window glass repair. Let's talk about broken glass in a fixed window, often known as a photo window. The most frequent type could have metal stops on the exterior, around all four sides of the window glass. Sometimes these stops will be held-in place with screws, and other situations there will be metal stops that snap-in place. In some rare cases there will be a rubber material as opposed to steel. If you've the screw type, you remove every one of the screws and each part will come out. In case you have the metal snap in stops, vigilantly pry the end in the shape using a little, flat screwdriver or a putty knife. You would like to begin in a place and work along the end until it arrives. Don't pry too much as the stops may bend quickly. When you yourself have the rubber kind, pry a corner away using the screwdriver, seize it together with your hands, and pull out the rubber. The glass shouldn't fallout since there is a glue or tape on-the edge, holding the glass in place. From here, You will get your measurements for the new bit of glass. The glass sides can be exposed, and it is possible to hook your tape measure to-the side and get your width and height. Assess the glass thickness, If there is a hole-in the glass. If there's not just a hole, set on some gloves and vigilantly push on the glass where the crack is found. This may reveal the side so you can evaluate it. When you go to get the new glass, you're likely to desire a tube of plastic to replace the glue or tape holding the glass set up. When you get the glass home, you need to take away the old glass. Go inside and cut between the glass and frame applying an utility knife with a new blade. This will cut away the silicone or tape that is keeping the old glass. Make sure to wear heavy gloves in this process to prevent getting cut. Start at the top and cut across from spot to the other. Then cut-down one-side, from top to bottom. Do the other side the exact same way. If you have an opinion about marketing, you will probably claim to read about [http://www.amazon.com/Window-Breaker-Emergency-Keychain-Guarantee/dp/B00EFJWY8I/ the link] . At this time the glass should fall out. You need to place a tarp or sheet under the window to get the glass because it falls out. Employing a stiff putty knife, scrape off the old silicone or record from your figure. If there were placing blocks on the bottom, be sure to delete them. They become shims to enhance the glass off the underside. Now run a bead of silicone about 3/16' thick around the edge of the opening. Grab your brand-new glass on the sides, angle the base in and the top out, set the glass on the setting blocks, then gradually raise the glass up into position. Push just hard enough that all four sides of the glass contact the silicone, although not so hard that the glass makes contact with the steel frame. Install your external stops. Don't clear the glass for 24 hours hence the silicone may set up.
Revenir à la page
An Read Window glass repair part 2
.
Affichages
Page
Discussion
Voir le texte source
Historique
Outils personnels
Créer un compte ou se connecter
Navigation
Accueil
Cinéjeu
Forum
Modifications récentes
Page au hasard
Aide
Rechercher
Boîte à outils
Pages liées
Suivi des pages liées
Pages spéciales