Voir le texte source
De WikiCinéjeu.
pour
RC Helicopter Blade Tracking
Aller à :
Navigation
,
rechercher
As soon as you have tightened or loosened the correct linkage or linkages, you will need to have another person fly the helicopter again so that you can search at the blades. You are going to repeat this process as generally as needed until finally your blades are tracked effectively and they spin on the same plane. After you've completed correct blade tracking, your RC helicopter will take care of a ton smoother than it did in advance of and be substantially much easier to fly. RC helicopter blade tracking has been a thriller to a lot of new RC helicopter proprietors, but I'm heading to demystify the complete strategy for you suitable now so that you are going to have a finish comprehending of blade monitoring by the time you end reading this report. Initially, we require to response this significant question: What is blade tracking? In essence, blade monitoring is when a single rotor blade rotates in a circular movement and the following blade follows specifically at the rear of it. Each rotor blades spin on the similar aircraft with no 1 blade currently being better or decreased than the blade it's next. An additional way to glance at it is that both blades travel via the identical airspace designed by their spinning. If the rear blade is following the front blade on a greater or reduced airplane, then it can lead to a great deal of undesirable vibrations for the RC helicopter. How To Track Your Blades If [http://www.addabazz.com/index.php?p=blogs/viewstory/1301144 Blade 450 RC Helicopter Evaluation] you're flying your RC helicopter for the 1st time, you want to see if the blades are tracking adequately and you may well will need some [http://community.babycenter.com/journal/pain2swiss/10540198/rc_helicopter_blade_monitoring Blade 450 RC Helicopter Review] help from an seasoned RC helicopter pilot. You can test the blade tracking by merely hovering the helicopter in position at eye amount and looking at the blades as it hovers. If you see a ton of shaking and vibrating, your RC helicopter is more than probable not tracking [http://beta.truck.net/blogs/486885/713055/blade-450-rc-helicopter-review RC Helicopter Blade Tracking] adequately. If you're not positive if it's monitoring correctly, do this: Get two different hues of tape and apply a little strip of one color to one particular blade. Set a crimson strip on a single blade and a blue strip on the other blade. By employing a various shade on every blade, it can make it a lot simpler to see which blade might be out of track. Now that you have applied the colored tape, have an seasoned RC helicopter pilot hover the helicopter in location so that you can see the blades as they spin. As you observe the blades spin, you will know if they're in observe if you only see a one circle or both blades spinning on one line. If you see two circles or two traces, (purple earlier mentioned blue or vice versa) then you'll know that just one of the blades are off and requirements to be aligned. To appropriately monitor your rotor blades, you want to land the hovering RC helicopter initially. Immediately after the blades have stopped spinning, you can change the blade that is out of alignment.
Revenir à la page
RC Helicopter Blade Tracking
.
Affichages
Page
Discussion
Voir le texte source
Historique
Outils personnels
Créer un compte ou se connecter
Navigation
Accueil
Cinéjeu
Forum
Modifications récentes
Page au hasard
Aide
Rechercher
Boîte à outils
Pages liées
Suivi des pages liées
Pages spéciales